Complex Movements

If you have questions or comments concerning any non-support related 3Dconnexion topic, please use this forum.

Moderator: Moderators

Post Reply
brplatz
Posts: 3
Joined: Tue May 28, 2013 8:52 am

Complex Movements

Post by brplatz » Tue May 28, 2013 8:55 am

Not sure if this is Creo 2.0 or a hardware based limitation, but complex movements, such as rotating at the same time as rolling.

Right now it "jumps" between the two if you try and do them at the same time. So I have to rotate then roll to get the desired orientaion.

Brian

Bryan
Moderator
Moderator
Posts: 443
Joined: Thu Dec 07, 2006 1:37 pm
Location: Rochester NY

Re: Complex Movements

Post by Bryan » Tue May 28, 2013 10:37 am

Dear brplatz,

You may have your 'Dominant' Mode enabled.

See what results you get if you disable it.

Start
All Programs
3Dconnexion
3Dconnexion Control Panel
'App Configuration' Tab
Uncheck 'Dominant'

Sincerely,
Bryan
The more things change, the more they remain the same. ; ^ )

brplatz
Posts: 3
Joined: Tue May 28, 2013 8:52 am

Re: Complex Movements

Post by brplatz » Tue May 28, 2013 12:33 pm

Wow I feel stupid now!

I knew that it couldnt be correct.

Thanks a ton! Wow this thing is 100x better!

Post Reply