uncommanded rapid zooming and rotation

Questions and answers about 3Dconnexion devices on Windows.

Moderator: Moderators

Post Reply
mvogl
Posts: 2
Joined: Fri Oct 07, 2016 9:04 am

uncommanded rapid zooming and rotation

Post by mvogl » Fri Oct 07, 2016 9:16 am

I have been having problems with the mouse suddenly causing my 3D model to rapidly spin or zoom out. This can occur after I have been moving the mouse, or when I haven't been touching the mouse - I assume vibrations in my desk are setting it off. Sometimes the motion or zooming can be stopped by slightly moving the mouse in the opposite direction, but not always. I use the space mouse with ANSYS Workbench 16.1 and Inventor 2014.

Barbara
Moderator
Moderator
Posts: 534
Joined: Fri May 14, 2010 11:11 am

Re: uncommanded rapid zooming and rotation

Post by Barbara » Fri Oct 07, 2016 10:36 am

Hello mvogl -

Re-centering your device is done with the “Calibrate” function in the System Tray options.
Locate the 3Dconnexion icon in the System Tray. Right-click and choose “Calibrate"

A window will ask you to not touch the cap while LEDs are blinking. Click OK then after a few seconds a window will inform you that calibration is finished.

Calibration returns the cap center to 0,0 so it corrects kind of the onscreen movement that happens when the cap is off-center.
---------
Barbara

Post Reply